⇩ Switch interface tabs with the buttons below to view documentation for each tab ⇩
Trapezoidal Thread \\ Fillet / Chamfer Tab (Tab 2):
Set the radius or chamfer size on corners of the thread profile.
Fillet/Chamfer : Value here is the calculated radius/chamfer for the thread defined in Tab 1.
Chamfer Angle : Angle of chamfer. Click the radio button to switch to chamfer. The value in the Fillet/Chamfer input box will then be used as the size of the chamfer.
For Trapezoidal threads, the Crest values for both sides must be equal and the Root values must be equal.
Control buttons at the bottom.
Use the buttons at the bottom of the ThreadTracer dialog to turn on or off actions to make.
Everything in the window is controlled by the 'Do It' button.
You can turn on/off options, generate visual geometry, change cut depths, change tool sizes and everything will be recalculated and updated when you press 'Do It'.
As long as the 'Process Ops' or 'NC Postprocessor' are disabled, no GibbsCAM operations or g-code will be generated.
Set up the all the roughing and finishing of the thread and only enable 'Process Ops' when everything seems correct. With 'Process Ops' enabled it will generate GibbsCAM threading operations.
Material Control : This will enable material control, and keep all threading cuts within the set limits. By default the limits are always set to Major and Minor diameter.
Do Roughing : This will enable roughing of the thread. When enabled it will run the roughing of the selected thread with the set tool parameters.
Do Finishing : This will enable finishing of the thread. When enabled it will run the finishing of the selected thread with the set parameters.
Process Ops : This will create GibbsCAM threading operations for all the calculated thread coordinates.
'Do Roughing' and 'Do Finishing' can be set individually. If only 'Do Finishing' is enabled and 'Process Ops', it will only create GibbsCAM threading operations for the finishing passes.
Click 'Do It' button to start running the options that's selected.
Click 'Save Data' to store the current thread setup into the GibbsCAM program
It will create a new data entry if its a new thread, after the thread setup is stored the button will change to 'Update Data'.
This way you can store and update the same thread entry, and not create a completely new thread entry every time the 'Save Data' is clicked.
If you need to create a new data entry in the GibbsCAM part, you must close ThreadTracer and restart it, and it will now start with a new data entry.
These lines of text can also be copied and pasted into other GibbsCAM programs, to quickly recreate the thread without typing in all the parameters again.
Page accessed : 124 times