It might be required to do a hard refresh (Ctrl + F5) in the webclient and force your browser to bypass its cache and reload to get the latest update.
Changelog
5.0.30
Improved setup for thread standards. Selecting a thread spec now show an expanded window with tolarance table of Major,Pitch and Minor diameters (max/min)
Added more thread standards, Knuckle Threads (DIN20400/DIN405), Trapezoidal (DIN30295) and Buttress (BS1657/DIN513/ANSI B1.9)
The thread calculators for all the included standards have a realtime graphic preview of the profile (w zoom/pan)
5.0.28
Added support for custom entry and retract, lets you guide the threading tool to its destination surface with a series of points.
Improved setting up custom stock. Place points for the workpiece coordinated with mouse.
Added VTL configuration for NC-SIM.
5.0.26
Support for multiple threads per setup. Its possible to program upto 8 threads onto same workpiece. Primary useage for cable & hoist drums with multiple righthand and lefthand cable grooves.
Implemented a built-in helix calculator for quickly setting up helix revolutions based on centerpoints. Helpful for grooves for cable & hoist drums.
Support for simulating threads with variable pitch. NC-SIM picks up K value directly from G-code.
Fixed zoom-to-mouse in canvas.
5.0.24
Added collision detection in NC-SIM. Visual coloring if any rapid moves enters material.
Added Wave chipbreaker, applies oscillating movements for threading passes in order to break chips during machining.
Overall improvements, better performance and general cleanup.
Added Spacemouse detection in NC-SIM.
5.0.22
ThreadTracer NC-SIM. New G-code simulator with orthographic projection. Simulates all threads.
5.0.21
Better number inputs, detect , and . when using numeric keyboard, improved inline math and added support to convert numbers to metric<->inch directly in the input field. (m and i key)
Fixed, Surface speed and taper angle was not stored between sessions.
5.0.20
Fix in comment line information in G-code output when in inch mode.
5.0.19
added support for tapered threads, taper is set as a radial slope and not direct angle so for an NPT taper, set as 1/32 or 0,03125 = 1.7899 degrees.
added hotkeys F1-F8 to switch tabs, and Z key to reverse scrollwheel zoom direction.
5.0.18
added custom header and footer fields for ISO post processors.
added support for 3Dconnexion Spacemouse.
5.0.17
added Import of ThreadTracer settings from GibbsCAM.
added Adaptive Finishing with sliders for angle threshold, curve desnity and look-ahead.
improved finishing logic.
added No Drag toggle for finishing.
added Reverse Finish Direction for finishing.
added Run In and Run Out.
added Full Profile Exit.
performance speedup on rendering workscreen.
5.0.15
added toggle for VTL orientation (toggle between vertical and horizontal machine view).
fix correct RPM output in template post processor.
